requesting two nodelists in the same paraview plotlist section causes a segmentation fault.
Version: Debian Jessie, marsD100, 2016.8.00
PlotList ./Paraview/Nodes Paraview {
DeleteAllFiles
TimeInterval 1.0 us
ndL MechEndR { } // nodes of bottom BC
ndL MechEndL { } // nodes of top BC
// use 'Glyph', Type 'Sphere' to plot
}
Paraview nodelist
3 posts
• Page 1 of 1
Paraview nodelist
by rwendner » Thu Aug 04, 2016 5:31 pm
- rwendner
- Posts: 154
- Joined: Wed Jul 15, 2015 4:35 pm
Re: Paraview nodelist
by rwendner » Fri Aug 05, 2016 8:55 am
I have the same problem on my MacBook.
It stops in some of the runs (sometimes it runs through without problem).
If it stops, it always stops at the
Writing plot file ./Paraview/NodeField.xxx.vtu
line.
This also happens (but rarer) if only a single nodelist is plotted.
I assume this has to do with how fast the writing operation is completed compared to the next write attempt.
It stops in some of the runs (sometimes it runs through without problem).
If it stops, it always stops at the
Writing plot file ./Paraview/NodeField.xxx.vtu
line.
This also happens (but rarer) if only a single nodelist is plotted.
I assume this has to do with how fast the writing operation is completed compared to the next write attempt.
- Attachments
-
- Screenshot 2016-08-05 10.54.33.png (260.79 KiB) Viewed 5550 times
- rwendner
- Posts: 154
- Joined: Wed Jul 15, 2015 4:35 pm
Re: Paraview nodelist
by zhouxinwei » Fri Aug 05, 2016 8:35 pm
Bug is confirmed and fixed in version 2016.8.05.
- zhouxinwei
- Posts: 208
- Joined: Thu Jul 09, 2015 7:12 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests