Hello,
I am trying to simulate a mechanical test -notched 3 point bending- on a 1"x1"x5" (0.5" notch) mortar specimen. The simulation has to include the HTC model and the Aging module. So basically, I set the LDPM parameters at a certain age (let's say at age 16 of the mortar) and then, I use the HTC model and the aging module to get the new LDPM parameters. The last step is to perform mechanical simulations using LDPM (compression, 3pbt) at age 6 of the specimen.
Each step works independently: the 3 pbt, the HTC model, and the aging module. The aim is to use the one way coupling and include the aging module (and later the ASR module).
The problem comes when I combine in a same file these steps: I get the following message "segmentation fault".
How could I solve this issue?
Thanks, Madura.