The command Write PartMeshDataFile exports as expected all selected elements (I tried a TetSolidList).
However, it exports ALL the nodes of the original mesh. This is quite useless and wasting storage.
A PartMeshFile should only export the selected elements and the required nodes.
write PartMeshDataFile
3 posts
• Page 1 of 1
write PartMeshDataFile
by rwendner » Mon Aug 08, 2016 5:56 pm
- rwendner
- Posts: 154
- Joined: Wed Jul 15, 2015 4:35 pm
Re: write PartMeshDataFile
by zhouxinwei » Wed Aug 10, 2016 3:48 am
The suggestion will be included, thanks.
- zhouxinwei
- Posts: 208
- Joined: Thu Jul 09, 2015 7:12 pm
Re: write PartMeshDataFile
by zhouxinwei » Thu Aug 11, 2016 12:40 am
Implemented in version 2016.8.12
- zhouxinwei
- Posts: 208
- Joined: Thu Jul 09, 2015 7:12 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest